OK so I got marinco connectors. On the female side it has 4 wires 2 pos 2 neg. The positive wires on the batteries each have their own 40 amp. Breakers. On the male side I got 24/12 volt options. When I first tested the male side it showed -24volts. I switched the leads from trolling motor to show 24v it shows this voltage from the back side of the plug where wires connect. Tighten the wire screws hit the power button on the trolling motor and it does nada. I am at a total loss. Motor is a 24v minnkota ulterra 80. Where should I go from here? Think it's the plug even though it all tests out? Wires from trolling motor are 10 ga. Factory wiring in the boat unmolested. Those wires to the female side look to be 8 ga. Old motor was a 24v motorguide and worked up till end of last yr.
Help with trolling motor wiring. Can't figure it out.
Aucun commentaire:
Enregistrer un commentaire